GLOSSARY / MANUFACTURER DIRECT
A current transformer (CT) ratio describes how current in its primary circuit relates to current in its secondary circuit. A ratio such as 400:5 means 400 amperes on the primary correspond to 5 amperes on the secondary under the stated conditions. That relationship lets compatible meters and protective relays measure or respond to current without carrying the full primary current through their inputs. Choosing a ratio is not just matching a number: the expected load, fault levels, connected devices, and application all matter.
Reading the Ratio
A CT ratio is written as primary current to secondary current, commonly in amperes. For a 400:5 CT, 400 A of primary current corresponds nominally to 5 A at the secondary. The ratio is 80:1, so a 2 A secondary reading represents about 160 A primary, assuming the CT and measurement setup operate within their specified conditions. Many systems use a 5 A or 1 A secondary, but the compatible value depends on the meter, relay, wiring, and design. The ratio is not a voltage ratio, and it does not mean the CT limits primary current to the number shown. It describes how current is represented at the secondary. Nameplate information and manufacturer documentation should be checked, since ratio taps, accuracy, burden limits, and other characteristics vary by CT.
Why Metering Uses It
For metering, the CT scales a large circuit current to a smaller signal that a compatible meter can measure. The meter uses the selected ratio to calculate and display primary current. If a meter is configured for 400:5 but the installed CT is 600:5, the displayed value can be materially wrong unless the configuration is corrected. Ratio selection should reflect the expected operating range, not just the equipment’s maximum nameplate current. A ratio that is much higher than typical load current may leave ordinary readings less useful for the chosen measurement task; a ratio that is too low may not suit expected current conditions. Buyers should confirm the meter’s secondary input, required accuracy, and CT ratio settings together. Metering purpose and actual load profile help establish a suitable choice.
Why Protection Uses It
Protective relays also depend on CT signals, but the selection question includes how the CT and relay behave during abnormal conditions. The relay must receive a signal suitable for its protection function, while the CT must be appropriate for expected current levels and the connected circuit. A ratio that works for normal-load metering is not automatically the right choice for protection. Engineers may need to consider fault current, relay input requirements, CT accuracy or performance class, and the burden of connected wiring and devices. The ratio affects the current presented to the relay, but it alone does not establish that the protection scheme will operate as intended. Confirm the CT data and relay application as part of the design review; do not choose solely by matching a familiar ratio.
Selection Tradeoffs
A practical selection starts with the system’s expected normal current and the maximum conditions the design must accommodate. The chosen ratio should provide a useful secondary signal for the intended meter or relay while remaining suitable for the application’s higher current demands. Buyers should verify whether a CT has a single ratio or selectable taps, which tap is intended for use, and whether the connected equipment accepts a 1 A or 5 A secondary. Accuracy requirements, connected burden, physical arrangement, and the protection or metering purpose can change the decision. A larger ratio is not automatically safer or better, and a lower ratio is not automatically more precise in every application. Ask the project engineer or equipment supplier to confirm the complete CT specification against the one-line diagram and device requirements.
Verify the Application
Before specifying CTs in a new switchgear or switchboard assembly, provide the supplier with the system voltage and current information, intended metering or protection function, device models or input requirements, and relevant drawings. Have the ratio, secondary rating, taps, accuracy requirements, burden, and physical fit reviewed together; not every detail can be inferred from the ratio alone. For custom new equipment, Switchgear Builder Virginia can work from project requirements to develop a build for review, with schedules and ratings subject to quote and verification. Confirm the final CT details against approved project documents before release. Where an existing system is involved, its drawings, installed CT nameplate, and connected-device settings may need qualified review. Do not assume that changing a ratio or device setting by itself resolves a measurement or protection concern.
